Serpent SER401941 CVD Driveshaft BB - Offroad Ready Replacement  [SER401941]

Serpent SER401941 CVD driveshaft BB
Price:
AUD$29.14
Brand:
Serpent
Model:
SER401941
Condition:
Brand New
Write a review

Sturdy CVD Driveshaft Solution from Serpent

The Serpent SER401941 CVD Driveshaft BB is a serviceable upgrade aimed at increasing drivetrain toughness and improving power transmission. It stands up to rough runs while helping reduce unwanted slop in the drivetrain.

Built for Tough Running

This driveshaft is made to take impacts and maintain alignment under load, giving a solid mix of strength and controlled flex. The result is fewer breakages and steadier handling when pushing hard.

Recommended Applications

Perfect for off road use and aggressive bashing, the driveshaft helps preserve momentum and keeps throttle response sharp by reducing losses through the driveline.

Will this fit stock axles?

Many stock setups accept this style, but measure axle diameter and spline count to be sure. Adapters are sometimes used when mixing parts from different makers.

Any setup advice after install?

After fitting, run the car slowly to check for binding through the full suspension range and tweak camber or toe if needed to avoid tight spots.

Can I use this with high power motors?

Yes, it is suitable for higher power setups, though monitoring wear and upgrading surrounding components like bearings and cups will help longevity.

How do I spot wear early?

Look for play in the joint, visible scoring on the cups, or rough bearings. Address small issues early to avoid sudden failure during a run.

Copyright © 2008-2025 rcjaz.com.au All rights reserved