Serpent SER401963 X20 Front and Rear Aluminum Chassis Brace  [SER401963]

Serpent SER401963 Chassis brace Front/Rear Aluminium X20
Price:
AUD$15.62
Brand:
Serpent
Model:
SER401963
Condition:
Brand New
Write a review

Reduce flex on the Medius X20 with Serpent SER401963 aluminium brace

Built for the Medius X20 family, the Serpent SER401963 aluminium chassis brace provides a straightforward way to firm up the chassis. It fits front and rear positions to help keep handling consistent under load.

Where it fits and what it does

The component fits the Medius X20 '21 MID 1/10 EP models and offers a precise match to factory mounting points. By stiffening the chassis ends, it can improve stability on long straights and through sweeping corners.

Practical installation advice

When installing the Serpent SER401963, alternate screw tightening to ensure even clamping and recheck after initial sessions. Routine checks prevent loose fixings and maintain the brace's benefit.

Can I fit this without removing the electronics?

In many setups the brace can be fitted with minimal disassembly, but access depends on your electronics layout. Plan the install to avoid disturbing wiring and components.

Will it affect tuning balance?

Adding stiffness at front and rear changes how the chassis transmits forces, which can alter balance. Use small setup changes to regain preferred handling rather than big adjustments.

Is any special maintenance needed?

Keep the brace and mounting points clean and check fasteners periodically. Simple maintenance keeps the part working as intended.

Does this require replacement mounting hardware?

The Serpent SER401963 is designed to use the standard mounting holes; your existing hardware will usually work but inspect fasteners for wear and replace if necessary.

Copyright © 2008-2025 rcjaz.com.au All rights reserved