Serpent SER411411 R Rear Axle Holder Aluminium for F110 SF4  [SER411411]

Serpent SER411411 Rear axle holder R Aluminium F110 SF4
Price:
AUD$30.93
Brand:
Serpent
Model:
SER411411
Condition:
Brand New
Write a review

Stiffer Rear Support with Serpent SER411411

The Serpent SER411411 rear axle holder is a practical upgrade for the F110 SF4 chassis. Its aluminium construction increases rear stiffness and supports consistent handling during both race and practice runs.

Tailored Fit for F110 SF4

Engineered for the F110 SF4 layout, this holder delivers accurate alignment and a secure connection to the rear assembly. The design helps maintain the chassis geometry under load.

Durability for Club Racing

Made from quality aluminium, the SER411411 is built to resist wear from regular track use while keeping weight low. Drivers should see steadier corner exits and improved confidence at speed.

Will fitting this change car balance?

Weight changes are minimal since the part is aluminium. Any balance change is usually positive, offering a firmer rear end and slightly crisper handling rather than a big shift in balance.

Are replacement screws included?

Check the parts listing for included hardware. In most cases you can reuse the original fasteners, but inspect them for wear before reassembly.

How often should I inspect the axle holder?

Inspect the holder after any hard impact and during routine maintenance. Look for loose fasteners, cracks, or deformation and replace if any damage is present.

Copyright © 2008-2025 rcjaz.com.au All rights reserved