Serpent 421019 40T Track-Ready Gear  [SER421019]

Serpent SER421019 Gear 40T
Price:
AUD$12.26
Brand:
Serpent
Model:
SER421019
Condition:
Brand New
Write a review

Precision cut 40 tooth gear for Serpent S240

Keep your Serpent S240 Electric Pancar running true with the Serpent 421019 40T gear. It provides accurate tooth geometry to help maintain steady drivetrain behaviour under race conditions.

Engineered for steady torque and low wear

The 40T gear is produced with attention to material resilience and tooth accuracy, reducing premature wear and helping to retain smooth power transfer. It is intended for regular track use and tuning setups.

Installation and compatibility details

Designed to fit the Serpent S240 Electric Pancar range, this gear installs as a direct replacement and is suitable for both race and hobby builds. Check gear mesh and bearing fit during installation for best results.

Does this replace the stock gear directly?

Yes, the Serpent 421019 is intended as a direct replacement for the stock S240 gear, matching mounting points and tooth count for straightforward swapping.

Should I change bearings when fitting this gear?

Inspect bearings for play and smooth rotation. Replacing worn bearings at the same time as the gear is a good preventive step to avoid premature gear wear.

What checks should I do after installing?

After fitting, verify gear mesh, free rotation, and that the transmission runs quietly without binding. Perform a few low-speed runs and recheck mesh before full-power use.

Copyright © 2008-2025 rcjaz.com.au All rights reserved