Serpent 500206 Rear Antiroll Bar 1.3mm for SRX2 - Handling Upgrade  [SER500206]

Serpent SER500206 Antiroll bar Rear 1.3 SRX2
Price:
AUD$7.81
Brand:
Serpent
Model:
SER500206
Condition:
Brand New
Write a review

Rear Antiroll Precision from Serpent 500206

The Serpent 500206 Rear Antiroll Bar is designed to sharpen the rear behaviour of SRX2 cars. Its 1.3mm section reduces excessive roll so the rear end stays more settled under cornering loads.

Consistent Response for Club Racing

By limiting lateral chassis tilt, the Serpent 500206 helps drivers achieve more predictable turn-in and throttle application. Its sturdy make supports repeated track sessions.

Plug and Play Fitment

Designed for the SRX2 architecture, this antiroll bar installs directly to the stock mounting points and works alongside standard rear suspension components.

Is this compatible with aftermarket SRX2 setups?

It fits standard SRX2 rear mounts and is compatible with many common aftermarket components, but check geometry if you run heavily modified layouts.

How durable is the Serpent 500206 in regular use?

The bar is constructed for routine track use and will hold up under normal racing stresses when correctly installed.

Should I change other settings when fitting this bar?

Adjusting rear shock rates or roll centre settings can help fine tune the balance after installing the 1.3mm bar. Make incremental changes and test between runs.

Does it affect straight line stability?

Mainly it alters lateral roll; straight line stability is usually unchanged unless the overall setup is shifted significantly.

Copyright © 2008-2025 rcjaz.com.au All rights reserved