Serpent 500612 SDX Front Anti Roll Bar 1.2mm - Race Setup [SER500612]

Serpent SER500612 Antirollbar Front 1.2mm SDX

Price:

AUD$7.57

Brand:

Serpent

Model:

SER500612

Condition:

Brand New

Quantity:

Write a review

Description
FAQ

Tune SDX corner control with Serpent 500612

The Serpent 500612 front anti roll bar at 1.2mm provides extra resistance to body roll and helps sharpen cornering on the SDX chassis. It is tailored to the SDX layout to deliver straightforward handling improvements.

Built for consistent track performance

Constructed to handle routine race stress, the Serpent 500612 keeps its stiffness under load while allowing fine tuning of front-end behaviour. Fitment is direct to SDX mounts, making it an easy upgrade for focused setups.

Can I use this on carpet or tarmac?

The 1.2mm front bar suits a range of surfaces; on high-grip carpet you may notice reduced roll and crisper turn-in, while on low-grip surfaces it will generally give more predictable responses.

Do I need special tools to fit it?

Standard hex drivers and a small spanner are usually all that is required. Take care to set link lengths evenly and check for binding during steering travel.

What should I change alongside the bar?

Adjust rear antirollbar, tyre pressures, and toe settings in small steps to complement the front bar. Keep notes so you can return to preferred baseline setups between tests.