Serpent SER500658 Heavy Duty Slipper Outdrive for SDX4 EVO  [SER500658]

Serpent SER500658 Slipper Outdrive for CVD (2) SDX
Price:
AUD$27.34
Brand:
Serpent
Model:
SER500658
Condition:
Brand New
Write a review

Fit the Serpent SER500658 to Your Spyder SDX4 EVO

Fitting the Serpent SER500658 slipper outdrive to a Spyder SDX4 EVO will sharpen drivetrain performance while coping with heavy use. Designed for CVD layouts, it evens out power flow and helps limit damage to linked components during aggressive driving.

Constructed for Endurance

This slipper outdrive is produced to resist the typical stresses of club and competition running, aiming to lower component fatigue. Its construction focuses on extending service intervals without compromising predictable behaviour on the circuit.

Mounting and Handling Benefits

The part is tailored to the Spyder SDX4 EVO for tidy fitment and straightforward replacement. Improved drivetrain efficiency from this upgrade often translates into steadier handling and more consistent lap times.

Is special tooling required to fit this outdrive?

Standard RC hand tools are usually sufficient; keep the service manual handy for torque specs and alignment checks during installation.

Does it change throttle feel?

It can make throttle response feel smoother by moderating sudden torque spikes, which helps drivers modulate power more effectively.

How often should I check the slipper outdrive?

Inspect it after high impact events and as part of routine maintenance every few runs to ensure splines and contact areas remain in good condition.

Copyright © 2008-2025 rcjaz.com.au All rights reserved