Serpent 500800 Front Steel Pivot Brace for SRX2 Gen3 - Track Tough Upgrade  [SER500800]

Serpent SER500800 Pivot pin Brace Front Steel SRX2 Gen3
Price:
AUD$13.59
Brand:
Serpent
Model:
SER500800
Condition:
Brand New
Write a review

Upgrade Front-End Stability on SRX2 Gen3

The Serpent 500800 Front Steel Pivot Pin Brace is a robust replacement part for SRX2 Gen3 cars, intended to increase longevity and support precise front suspension alignment. The steel build helps the chassis retain setup under demanding conditions.

Advantages of Steel Construction

Steel is less prone to deformation than softer materials, which translates to steadier suspension pivot points and reduced chance of setup drift. That durability suits frequent club or regional racing.

Compatibility with SRX2 Gen3

This brace is tailored to the SRX2 Gen3 mounting pattern for an accurate, hassle-free fit. Proper compatibility reduces the need for adjustments after installation.

Practical Fitment Advice

Before installing the Serpent 500800, remove any grit from mounting surfaces and inspect existing pins and screws. After fitting, run a quick alignment check to ensure steering response is unchanged.

Can the brace be used with aftermarket uprights?

Compatibility depends on the upright design. The Serpent 500800 matches SRX2 Gen3 factory mounting; check upright clearances and hole positions if using non-standard parts.

Do I need new hardware when fitting this brace?

Existing hardware usually works if in good condition, but replace worn screws or pins to ensure secure fastening and correct alignment.

How should I maintain the steel brace?

Keep the brace and pivot pins clean and check for corrosion or nicks. Light lubrication on moving parts can help, but avoid contaminating suspension pivot surfaces.

Copyright © 2008-2025 rcjaz.com.au All rights reserved