Serpent 500879 - Carbon Battery Plate for SRX2 Gen3 Track-Tuned  [SER500879]

Serpent SER500879 Batteryplate Carbon (2) SRX2 Gen3
Price:
AUD$24.06
Brand:
Serpent
Model:
SER500879
Condition:
Brand New
Write a review

Track-Tuned Carbon Battery Plate for SRX2 Gen3

Replace your SRX2 Gen3 battery holder with a track-focused carbon plate from Serpent. These plates are cut to provide a lightweight, rigid mounting point that helps the car respond more predictably under load.

High Strength, Low Mass Design

The Serpent 500879 uses quality carbon fibre to deliver a stiff, low mass solution that stands up to repeated track use. Its accurate profile holds the battery firmly, reducing unwanted movement during fast direction changes.

Edge for Setup and Stability

By trimming unnecessary weight and centralising the battery, these plates assist in lowering the centre of gravity and improving rotation. They are a good choice for drivers refining handling or seeking a durable upgrade for race day.

Does the Serpent 500879 require chassis changes?

No major chassis modifications are usually needed; the plate is designed to fit SRX2 Gen3 mounting points. Small adjustments or different screws may be necessary depending on your current setup.

Can I run this with foam or hard case packs?

Both foam and hard case packs can be used, but ensure the clamping method suits the pack type and add padding if needed to prevent movement with softer cells.

Is there a weight saving compared to stock?

Yes, carbon plates like the 500879 typically save a modest amount of mass versus stock plastic holders, which helps with balance and handling when combined with other setup changes.

Any tips for installation?

Use correct length screws and avoid over tightening. Check battery orientation and secure straps or clamps to prevent shifting during hard driving.

Copyright © 2008-2025 rcjaz.com.au All rights reserved