Serpent 600957 - SRX8E Aluminium Rear Center Driveshaft Durable Option  [SER600957]

Serpent SER600957 Driveshaft Center Rear Aluminium Saddle Layout SRX8E
Price:
AUD$22.02
Brand:
Serpent
Model:
SER600957
Condition:
Brand New
Write a review

Lightweight Aluminium Driveshaft for Consistent Torque

The Serpent 600957 Aluminium Rear Center Driveshaft is built to improve the SRX8E buggy's drivetrain response. Made from quality aluminium, it provides dependable torque transfer while cutting unnecessary weight, which supports crisper acceleration and steadier handling on loose surfaces.

Strength and Heat Management

Engineered for the SRX8E Buggy EP layout, the driveshaft is produced to tolerate repeated impact and load. Aluminium construction boosts resistance to wear and helps dissipate heat from high stress zones during longer runs.

Designed for Easy Installation

The Serpent 600957 matches SRX8E component geometry for a clean swap-in. Installation is straightforward and requires little in the way of chassis changes, making it a practical upgrade for regular racers and weekend tuners.

Does this replace the stock rear driveshaft directly?

Yes, it is intended as a direct fit for the SRX8E rear driveshaft position, though you should verify spline and length match your current hardware before fitting.

Will this change handling noticeably?

Reducing rotating mass can sharpen throttle response and slightly alter balance. Expect improved acceleration feel and potentially crisper corner exits on most surfaces.

What checks should I do after fitting?

After installation, run the buggy at low speed to confirm there is no binding, then recheck fasteners and spline engagement. Inspect after the first few runs and tighten as needed.

Copyright © 2008-2025 rcjaz.com.au All rights reserved