Serpent 601110 Performance Rear Antiroll Bar 2.4mm SRX8T Fit  [SER601110]

Serpent SER601110 Antiroll bar Rear 2.4mm SRX8T
Price:
AUD$8.31
Brand:
Serpent
Model:
SER601110
Condition:
Brand New
Write a review

Tighten Rear Control with Serpent 601110

The Serpent 601110 Rear Antiroll Bar is a focused upgrade for the Cobra SRX8 Truggy GP. At 2.4mm thickness it increases rear stiffness to limit excessive roll, helping drivers hold a cleaner line through faster bends.

Specifically Matched to Cobra SRX8 Geometry

Made to suit the SRX8 layout, this rear antiroll bar balances rotation and grip so the truggy feels more composed during corner entry and mid-corner phases. It is a sound choice for tuning rear-end behaviour without over-damping movement.

Consistent Performance Under Load

Produced with attention to fit and repeatability, the Serpent 601110 delivers stable characteristics over repeated runs. That consistency makes setup changes easier to evaluate at the track.

Is this antiroll bar a direct swap for SRX8 parts?

Yes, the 601110 is produced for the Cobra SRX8 Truggy GP and fits standard rear mount points on that chassis without extra modification.

Will this make the truggy understeer?

Increasing rear roll stiffness can shift balance slightly toward understeer in some setups. Counter this with front bar or shock tuning if needed to maintain desired handling.

How do I decide between 2.4mm and other sizes?

Compare feel by swapping bars on the same track; 2.4mm is a middle-ground option that firms the rear without making the chassis feel locked. Use it as a baseline when building a setup chart.

Copyright © 2008-2025 rcjaz.com.au All rights reserved