Serpent 601194 - SRX8 RTR Rear Suspension Bracket Heavy-Duty Mount  [SER601194]

Serpent SER601194 Suspension Bracket Rear Rear SRX8 RTR
Price:
AUD$6.86
Brand:
Serpent
Model:
SER601194
Condition:
Brand New
Write a review

Reinforce the Rear of Your SRX8 RTR

The Serpent 601194 rear suspension bracket serves as a sturdy replacement to enhance the rear mounting on SRX8 RTR vehicles. Tailored for Cobra SRX8 Buggy and Truggy EP RTR models, the design emphasises durability and predictable handling across varied off-road conditions. Its reinforced profile helps limit unwanted movement in the rear suspension under load.

Improved Reliability for Tough Runs

Carefully produced for consistent fit, the Serpent 601194 rear suspension bracket adds strength without compromising setup. It is well suited to those who demand repeatable performance during competitive events or heavy backyard use. Swapping in this bracket can reduce stress-related failures and keep your chassis performing reliably.

Simple Fitment with Common Tools

This replacement is compatible with Cobra SRX8 Buggy and Truggy EP RTR platforms and installs using standard RC tools. The quick installation process makes it an efficient upgrade to improve rear stability and tuning consistency.

Will this bracket work with aftermarket arms?

If the aftermarket arms retain the stock mounting points for the SRX8 RTR, the bracket will generally fit. Always check hole alignment before final assembly.

Can I reuse the original hardware?

In most cases the original screws and bolts can be reused, but inspect them for wear and replace any stripped or corroded fasteners for a secure fit.

Does the bracket change shock geometry?

The bracket is a like-for-like replacement aimed at reducing flex rather than altering geometry; your existing shock mounts and angles remain the same unless you change related components.

Copyright © 2008-2025 rcjaz.com.au All rights reserved