Serpent 601195 SRX8 Front Suspension Bracket Off-Road Favourite  [SER601195]

Serpent SER601195 Suspension Bracket Front Front SRX8 RTR
Price:
AUD$10.42
Brand:
Serpent
Model:
SER601195
Condition:
Brand New
Write a review

Front mount bracket for SRX8 suspension

The Serpent 601195 suspension bracket is a direct-fit component for SRX8 RTR vehicles designed to tidy the front suspension layout and reduce unwanted movement. Accurate fitment helps maintain predictable handling across multiple runs.

Stable geometry for confident driving

Produced by Serpent to suit the Cobra SRX8 platform, this bracket improves rigidity at the front end and supports consistent steering behaviour under load. It is aimed at drivers who race regularly and need repeatable setup results.

Compatibility checklist and install guide

This item fits the Cobra SRX8 Buggy Series and the Cobra SRX8 Truggy EP RTR (SER600039). Installation is simple, and a brief setup check after fitting will ensure steering and toe are back to the correct settings.

Can I use this on a converted SRX8 chassis?

If the conversion retains the factory front mounting points, the bracket will fit. Confirm mounting hole alignment before tightening fully.

Will this bracket affect suspension travel?

The bracket is designed to maintain the intended travel while improving stability; it should not reduce usable suspension movement when fitted correctly.

Any break-in or bedding in required?

No formal break-in is needed, but inspect the bracket and fasteners after the first few sessions to ensure nothing has shifted.

Recommended checks after installation?

Verify fastener torque, confirm suspension geometry, and perform a short test run to check steering response and tyre wear patterns.

Copyright © 2008-2025 rcjaz.com.au All rights reserved