Serpent 601232 Steeringblock Ballstud Set - Track-Ready Upgrade  [SER601232]

Serpent SER601232 Steeringblock ballstud
Price:
AUD$25.02
Brand:
Serpent
Model:
SER601232
Condition:
Brand New
Write a review

Tough Steering Precision with Serpent 601232

If you push a Cobra SRX8 GT hard, the Serpent 601232 Steeringblock Ballstud Set helps keep steering direct and repeatable. These studs are made to provide predictable linkage action under demanding driving.

Matched to Cobra SRX8 GT Chassis

The Serpent 601232 components are produced to suit the Cobra SRX8 GT, offering a clean fit and simple swap-in installation. They assist drivers in preserving steering geometry and reducing slack on fast sections.

Reliable Under Race Conditions

Built from materials chosen for durability, these ballstuds resist the loads of aggressive driving. Their solid construction promotes long service life and consistent handling for focused RC enthusiasts.

Do these studs fit non-GT Serpent cars?

They are engineered for the Cobra SRX8 GT, so fitment on other Serpent models depends on identical steeringblock geometry. Verify measurements before assuming compatibility.

What torque or tightness is recommended?

Hand-tighten to secure then check for free movement without binding. Avoid over-tightening which can bind the ball joint or damage threads.

Are there common upgrades to pair with these?

Many drivers pair upgraded ballstuds with hardened turnbuckles or improved servo mounts to reduce flex and sharpen steering feedback.

How should I clean them after outdoor use?

Rinse off grit, dry thoroughly, and apply a light, appropriate lubricant to protect the contact surfaces without attracting dust.

Copyright © 2008-2025 rcjaz.com.au All rights reserved