Serpent 804118 Front Pivot Pins - Race Ready Component  [SER804118]

Serpent SER804118 Pivot pin Front up (2)
Price:
AUD$13.82
Brand:
Serpent
Model:
SER804118
Condition:
Brand New
Write a review

Keep Steering True with Serpent 804118 Pivot Pins

The Serpent 804118 front pivot pin kit is aimed at racers who want dependable steering behaviour. These pins are suitable for several RC chassis and help keep steering precise under hard use. Whether swapping out worn pins or fitting an upgrade, they support predictable handling during competition runs.

Durability That Supports Setup Work

Made to tight tolerances, the Serpent 804118 pins reduce unwanted movement and resist premature wear. Their secure fit helps maintain the chassis steering geometry, letting you run consistent setups with less fuss. That stability is useful when fine tuning camber and steering response.

Simple Installation Steps

  • Check that Serpent 804118 matches your chassis pin dimensions before installation.
  • Fit with care using the right tools to prevent scratching or bending the pins.
  • Perform routine inspections after heavy track sessions and replace if noticeable play develops.

Do Serpent 804118 pins require break in?

There is no special break in procedure; install correctly and check for smooth steering movement and correct alignment after a few practice laps.

Can these pins improve steering feel on worn hubs?

If play originates in the pivot pins, replacing them with Serpent 804118 can restore a firmer steering feel, though worn hubs or bearings should also be checked.

Are any special retainers needed?

Use the retention hardware specified by your chassis; do not jury rig clips or adhesives as they can affect steering geometry and serviceability.

How often should I inspect the pins during race weekends?

Give a quick visual and manual check between heats, focusing on any increase in freeplay or visible damage, and replace if performance is affected.

Copyright © 2008-2025 rcjaz.com.au All rights reserved