Serpent SER804436 1/10 Natrix 750 Drive Belt Tensioner  [SER804436]

Serpent SER804436 Belt Tensioner set 1/10
Price:
AUD$45.24
Brand:
Serpent
Model:
SER804436
Condition:
Brand New
Write a review

Serpent SER804436 Tensioner for Natrix 750 Drive Trains

The Serpent SER804436 Belt Tensioner improves belt control on the Natrix 750 200mm GP car so power is passed to the wheels more reliably. By stabilising belt tension it helps reduce slip and extends the service life of drivetrain parts under demanding use.

Precision Fit and Function

Engineered for the Natrix 750 chassis layout, the Serpent SER804436 keeps belt tension within a narrow band to smooth out throttle response and reduce uneven wear. A stable belt means more consistent exits from corners and fewer drivetrain surprises.

Installation Steps

Installation is manageable with basic RC tools and a steady bench. Ensure the tensioner sits flush with the mounting plane, torque fasteners evenly, and recheck belt alignment after a short run to confirm settings.

Will the tensioner change how the car feels on dirt versus asphalt?

The unit stabilises belt behaviour on any surface, reducing belt slip that can be more noticeable on loose surfaces. It does not change suspension or tyre grip characteristics.

How long does installation usually take?

For a competent hobbyist the job typically takes under an hour including setup and a short test run to fine tune tension settings.

Are spare parts for the tensioner available?

Wear items like small screws or bushings can be replaced if needed. Keep original hardware and check local parts listings for compatible spares.

How often should I adjust the tension after installation?

Check tension after the first few laps and after any heavy running session. Small tweaks are normal as belts bed in and settle into position.

Copyright © 2008-2025 rcjaz.com.au All rights reserved