Serpent 903686 Rear Carbon Shock Tower for S988 - Carbon Reinforced  [SER903686]

Serpent SER903686 Shocktower Rear carbon S988
Price:
AUD$25.39
Brand:
Serpent
Model:
SER903686
Condition:
Brand New
Write a review

Stiff Rear Carbon Tower for S988 Chassis

The Serpent 903686 rear carbon shock tower is a direct replacement part that tightens up the rearend behaviour of the S988 chassis. It is aimed at hobbyists wanting a robust, light solution for faster cornering and repeatable setup changes.

Material Advantages of Carbon

Carbon construction reduces flex while saving weight compared with heavier materials. This can translate into sharper steering transitions and improved rear end predictability during high speed runs.

Compatibility Notes and Installation

Because it matches the S988 mounting pattern, installation is quick and uses existing hardware. The tidy fitment also makes it simple to fine tune shock positions without extra adapters.

Can I swap this onto older S988 builds?

Yes, it retrofits to earlier S988 cars that retain the same shock top geometry. Verify hole spacing and ensure shock towers on both sides match for symmetry.

Should I change shock oil after fitting?

Not mandatory, but pairing the tower with a small oil or spring rate change often helps you discover the handling gains. Start with minor adjustments and test progressively.

Is the Serpent 903686 brittle in cold weather?

Quality carbon is stable across typical temperature ranges; avoid exposing it to severe impacts when cold. Check for any damage after heavy contact with obstacles.

Copyright © 2008-2025 rcjaz.com.au All rights reserved