Servo Mixing Arm for Freya FFZ-III HI0414387 - Hirobo  [HI0414387]

HIROBO 0414-387 FREYA FFZ-III MIXING ARM #0414387
Price:
AUD$7.81
Brand:
Hirobo
Model:
HI0414387
GTIN:
4512895142070
Condition:
Brand New
Write a review

Tuning and Swash Geometry

This RC-scale mixing arm is provided as a replacement for Freya FFZ-III helicopter models and serves as the linkage element that carries servo output into the swashplate mixing geometry. It allows collective and cyclic inputs to combine consistently while you tune and trim the model.

Installation notes: make sure orientation and alignment with the swashplate and servo linkages are correct before final tightening. Verify ball-link clearance through the complete control travel and check neutral positions and control throws on the transmitter before powering up. Minor fit adjustments are recommended to prevent binding and ensure smooth control movement.

Tuning role: the component supports steady mixing behavior during swash geometry setup and collective pitch calibration, aiding precise trimming and pre-flight tuning sessions.

How will changing the mixing arm affect swash response?

Swapping the arm can alter leverage and the feel of the mixing; after fitment, re-establish neutral points and test small cyclic inputs to confirm expected response.

Any advice for fine trimming after fitment?

Begin with small trim changes at the transmitter, check collective and cyclic centring, and iterate until the swash geometry produces neutral flight without excessive cyclic correction.

Copyright © 2008-2026 rcjaz.com.au All rights reserved