Split Front Upper Deck for ARC A11 Graphite 2mm O-ARCP05 by Factory Pro  [FP-O-ARCP05]

Price:
AUD$17.49
Brand:
Factory Pro
Model:
FP-O-ARCP05
Condition:
Brand New
Write a review

Split upper deck — ARC A11

This item is a split front upper deck made to fit the ARC A11 chassis, supplied as Factory Pro part O-ARCP05. The component is a 2mm graphite plate arranged in a split configuration to modify stiffness ahead of the front bulkhead.

The split construction gives flexibility for tuners to change stiffness independently across each side or to experiment with different deck thicknesses. It is intended for 1/10 electric touring car setups and for detailed track tuning where small flex changes influence turn-in and front traction.

Installation uses the standard ARC A11 screw locations; swap this plate in place of the stock front upper deck using the same attachment points and hardware. After fitting, check clearances near the servo and suspension towers and perform short setup runs to confirm steering behavior and bump steer.

Do I need extra hardware to fit this deck?

No additional hardware is normally required; the deck uses the ARC A11 factory mounting points and standard screws. Retain your original screws unless damaged.

What clearances should I check after fitting?

Verify there is sufficient clearance around the servo horn, linkage, and the front suspension towers. Also check for any rubbing against electronics or wiring bundles.

Should I re-check steering geometry after install?

Yes. After installing the split deck carry out short track runs to confirm steering response and bump steer, and make small trim adjustments as required.

Copyright © 2008-2026 rcjaz.com.au All rights reserved