SRX8 Gen4 FR+RR Brake Cam Upgrade 601369 for Serpent  [SER601369]

Serpent SER601369 Brake cam FR+RR SRX8 Gen4
Price:
AUD$22.58
Brand:
Serpent
Model:
SER601369
Condition:
Brand New
Write a review

Front and Rear Brake Cam for SRX8 Gen4

This cam fits the brake linkage on Serpent SRX8 Gen4 cars and is intended as a replacement for worn items. It restores correct lever geometry while keeping the original chassis arrangement intact.

The part is only compatible with SRX8 Gen4 models; confirm your chassis code before purchase. Fitting is straightforward: remove the old cam, transfer any good linkage hardware, press in the new cam, then test lever travel and pad engagement through the steering sweep.

Mechanically, the cam aids in maintaining consistent brake bite and linearity between runs. Expect to perform small adjustments to servo neutral or linkage length after installation to fine tune pedal feel.

Specifications

  • Item Brake cam FR+RR
  • Material Not specified by manufacturer
  • Model Number SER601369
  • Compatibility SRX8 Gen4

Use this spare to replace tired cams on SRX8 Gen4 vehicles and keep braking consistent for precise track setup.

Will swapping the cam change brake balance?

It can alter lever ratio slightly and therefore affect bite; after replacement, re-evaluate balance and adjust linkage lengths if required to restore the desired feel.

How do I fine tune after installation?

Start by checking servo neutral and then make small changes to linkage length while testing braking performance until the desired pad timing and bite are achieved.

Does cam profile affect pedal feel?

Yes. The cam profile determines lever ratio across travel, so a new cam can change how progressive or immediate the brake response feels.

Are there recommended checks after fitting?

Verify secure fastening of all linkage parts, confirm smooth lever action, and test brakes at low speed before full running to ensure correct operation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved