SRX8 V2 Front and Rear Bracket Upgrade - Serpent 601385  [SER601385]

SRX8 V2 bracket: function and fit

Listed as Serpent model SER601385, this RC suspension bracket serves as a replacement part for front and rear mounting positions on SRX8-series race cars. It establishes the attachment geometry that influences alignment consistency and component wear in both practice and competitive driving.

The component is produced to match SRX8 V2 arrangements and can be used with SRX8 Gen4 GP layouts where the mounting geometry is shared. At chassis level it interfaces with uprights, lower arms, and the shock tower; accurate fitment and mirror symmetry are important when swapping brackets to keep the car balanced.

During setup the bracket will change roll centre and camber behaviour under load, so tuners often swap brackets to test geometry changes or repair chassis damage that affects mount locations. Always inspect threaded inserts, bore fits, and suspension travel after fitting to prevent any binding that alters handling.

Compatibility

• SRX8 V2
• SRX8 Gen4 GP (SER600024)

For Australian racers and garage builders working on SRX8 chassis, SER601385 offers a reliable replacement to restore correct mounting geometry and preserve predictable handling through setup iterations.