SRX8 V2 Front C-hub Pair 19° KPI Aluminium - Serpent 601388  [SER601388]

Price:
AUD$83.87
Brand:
Serpent
Model:
SER601388
Condition:
Brand New
Write a review

SRX8 V2 front C-hubs — aluminium 19° KPI

The Serpent 601388 set comprises left and right aluminium C-hubs made for the SRX8 V2 front steering assembly. Each hub is specified at 19° KPI and matched to ensure consistent left/right steering geometry. These components are intended to replace standard parts where SRX8 V2 mounting points are used and to provide a firmer metal option in the front suspension knuckle area.

Practically, switching to these C-hubs will adjust kingpin inclination at the front axle and will therefore affect turn-in characteristics and weight transfer during cornering. Use the hubs as part of an iterative tuning process: install, test steering response, then tweak toe, camber or roll centre on the SRX8 V2 chassis as necessary. Regular checks of mounting hardware and interfaces will help sustain consistent setup results.

The Serpent 601388 aluminium C-hub L+R is a performance-minded metal swap for SRX8 V2 front steering, aiding drivers who refine KPI-driven handling traits.

How should I introduce these hubs into my setup?

Fit one side at a time or the matched pair and run short tests to note changes in turn-in, then adjust other front-end settings to balance the car.

Will swapping to aluminium require other changes?

Often you will need small toe or camber tweaks to regain the desired steering feel after installing aluminium hubs, as KPI affects initial bite and weight transfer.

Do these affect lap times?

When matched to the rest of the SRX8 V2 setup, they can improve consistency through corners; measurable lap time impact depends on driver and track conditions.

Any special installation tips?

Ensure bearing seats and kingpin surfaces are clean, use thread-lock where specified, and confirm alignment before final tightening to avoid geometry shifts.

Copyright © 2008-2026 rcjaz.com.au All rights reserved