SRX8 V2 Steering C-hub 17deg KPI L+R SER601387 Serpent  [SER601387]

Price:
AUD$0.00
Brand:
Serpent
Model:
SER601387
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

SER601387 C-hub technical summary

This Serpent SER601387 C-hub set supplies left and right aluminium steering hubs for the SRX8 V2 platform, each machined to a 17deg KPI (King Pin Inclination). The part is targeted at drivers who use geometry tweaks to tune balance and tyre behaviour.

Fitting is direct to the SRX8 V2 upright and does not normally need extra machining. Use standard hand tools to swap the hubs, check tie rod length, and re-establish droop and scrub settings during setup. Verify bearing preload and wheel alignment after the swap before track work.

Tuning impact: the 17deg KPI adjusts scrub radius and steering response, influencing initial turn-in and centre steering feel. Test the hubs with incremental steering, toe and camber changes to observe their influence on understeer and oversteer. As an aluminium upgrade the hubs reduce flex for repeatable geometry across multiple runs.

Specifications

  • Item C-hub 17deg KPI L+R
  • Material Aluminium
  • Model Number SER601387
  • Compatibility SRX8 V2

For tuners focusing on steering response, these aluminium C-hubs provide a reliable platform to explore KPI-driven handling changes on the SRX8 V2.

How should I approach setup when fitting the SER601387 hubs?

Start with your baseline geometry and change only one variable at a time. After installing the hubs, test a short session to assess turn-in before altering toe or camber.

What steering adjustments pair well with a 17deg KPI?

Shortening or lengthening the tie rod by small increments and adjusting front toe are effective first steps. Monitor tyre scrub and mid-corner balance while tuning.

Will these hubs change tyre wear patterns?

Yes. A different KPI affects contact patch behavior during turn-in and cornering; track tyre wear over a few runs and fine-tune alignment accordingly.

Can I mix these aluminium hubs with other aftermarket uprights?

Compatibility depends on upright geometry and mounting points. These hubs are intended for standard SRX8 V2 uprights; verify fitment if using non-standard or heavily modified uprights.

Copyright © 2008-2026 rcjaz.com.au All rights reserved