SRX8 V2 Suspension Mount Upgrade for Tuning - Suspension bracket rr fr SER601383 Serpent  [SER601383]

Price:
AUD$36.47
Brand:
Serpent
Model:
SER601383
Condition:
Brand New
Write a review

SRX8 V2 suspension mounting bracket details

The Serpent SER601383 is a suspension bracket intended for SRX8 V2 chassis applications. It provides rear and front mounting points in the suspension architecture and is used as a direct replacement for factory components during setup changes or repairs.

Focus here is on function and setup influence: the bracket sets link and shock geometry, impacting roll centre and response when settings are altered. Because it locates critical pivot points where suspension hardware meets the chassis, accurate installation is important for consistent tuning results.

Fitment notes: remove only the hardware securing the damaged bracket, align the SER601383 with existing holes and pins, and refit using the original fasteners. Verify free suspension movement and wheel alignment, then perform a measured test run to evaluate handling before finishing your setup session.

Specifications

  • Item: Suspension bracket rr fr
  • Model Number: SER601383
  • Material: Not specified by manufacturer
  • Compatibility: SRX8 V2, SRX8 Gen4 GP (SER600024)

Ideal when preserving SRX8 suspension geometry is essential; always check alignment and travel after fitting to retain predictable handling during tuning.

How does this bracket affect roll centre adjustments?

The bracket fixes the relative positions of links and shocks, so replacing or changing it can change roll centre height. Expect different transient behaviour if pivot heights differ from worn components.

Can I tune differently after fitting a new SER601383?

Yes. A fresh bracket that restores original geometry gives you a consistent baseline for tuning; retest ride height, damper positions, and sway characteristics after installation.

Is there any break-in required?

No special break-in is required for the bracket itself. After fitting, run a brief test to confirm there is no binding and that mounting points remain stable under load.

Will swapping brackets affect shock mounting angles?

Potentially. Because shock eyelet positions are located relative to this bracket, a change can alter angle and leverage. Recheck shock position and rebound settings after installation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved