SSR-8 Tail Link Pitch Arm HI0414513 for Hirobo  [HI0414513]

HIROBO 0414-513 SSR-8 PITCH ARM #0414-513
Price:
AUD$31.02
Brand:
Hirobo
Model:
HI0414513
GTIN:
4512895151607
Condition:
Brand New
Write a review

SSR-8 pitch arm: function and setup

Sold under Hirobo part number HI0414513, this pitch arm is a direct-fit component for SSR-8 helicopters and is used to maintain the tail pitch control linkage. The focus here is on correct fitment, tuning effects, and installation practice.

As the connection in the tail pitch train, the HI0414513 affects trim response and should be installed with careful attention to alignment. After fitting, verify travel endpoints and neutral position while accounting for rotor head setup and tail rotor geometry.

Specifications

  • Item: Hirobo HI0414513 SSR-8 pitch arm
  • Material: Not specified by manufacturer
  • Model Number: HI0414513
  • Compatibility: SSR-8 helicopters

Use the HI0414513 to restore correct tail pitch mechanics on SSR-8 models; confirm alignment and control travel during tuning sessions.

How does the HI0414513 affect tail trim?

Replacing a worn arm with the HI0414513 restores the intended lever lengths and pivot geometry, which helps maintain predictable tail trim once neutral and endpoints are re-established.

Should I re-tune the tail after fitting?

Yes. After installing the HI0414513, re-confirm servo endpoints, sub-trims, and flybar or CCPM settings as appropriate to your SSR-8 setup for consistent flight behavior.

Can I use the existing link hardware?

If existing screws and bearings show no wear they can be reused, but inspect contact surfaces closely; replace any doubtful hardware to avoid slop in the HI0414513 installation.

Will this arm fit all SSR-8 variants?

The specification lists compatibility with SSR-8 helicopters; confirm physical fit against your specific SSR-8 airframe and related parts before final installation.

Copyright © 2008-2026 rcjaz.com.au All rights reserved