SSR-VI Replacement Stabilizer Control Arm - HI0414217 by Hirobo  [HI0414217]

HIROBO 0414-217 SSR-VI STABILZER CONTROL ARM #0414217
Price:
AUD$29.48
Brand:
Hirobo
Model:
HI0414217
GTIN:
4512895129231
Condition:
Brand New
Write a review

Function and fit notes

This Hirobo replacement control arm is intended for use in the SSR-VI stabilizer assembly on RC helicopters. The emphasis is on its function in establishing correct linkage geometry and predictable tail response; the listing does not assert details about construction materials. Fit the arm when replacing worn components or when adjusting stabilizer settings during setup.

Specifications

  • Item: Stabilizer Control Arm
  • Material: Not specified
  • Model Number: HI0414217
  • Compatibility: SSR-VI

Use this control arm to restore or fine tune SSR-VI stabilizer geometry. Always confirm correct fit before installation and verify linkage angles during initial setup to ensure stable tail control.

Will this arm fit the SSR-VI without modification?

It is listed for SSR-VI compatibility; however, always compare the mounting geometry and hole spacing on the spare part to your helicopter to avoid surprises during installation.

What role does this piece play in stabilizer setup?

The control arm sets the linkage geometry that governs small corrective inputs and tail-centre behaviour, so it is integral to predictable stabilizer response after tuning.

Are extra parts commonly required to fit it?

Usually existing linkage hardware can be reused, but inspect ball links and screws and replace any worn items to secure a tight, reliable assembly.

How should I check the install before flight?

With power off, move servos through their travel to check for binding or slack, then set and confirm a neutral stabilizer position on the ground prior to flying.

Copyright © 2008-2026 rcjaz.com.au All rights reserved