Stabilizer Control Arm Upgrade for Turbulence D3 SSZ-IV HI0414463 by Hirobo  [HI0414463]

HIROBO 0414-463 TURBULENCE D3 SSZ-IV STABILIZER CONTROL ARM #0414463
Price:
AUD$21.69
Brand:
Hirobo
Model:
HI0414463
GTIN:
4512895150600
Condition:
Brand New
Write a review

Stabilizer arm replacement for Turbulence D3 SSZ-IV

This part is an RC-scale stabilizer control arm from Hirobo, model HI0414463, intended for the Turbulence D3 SSZ-IV helicopter tail assembly. It is a suitable replacement when the factory component is damaged or when you want an on-hand spare for on-site repairs.

The arm is produced to match the original mounting points on the Turbulence D3 SSZ-IV tail framework; always verify linkage alignment and ball-bearing seating during installation. Because the arm affects tail geometry, perform a full range-of-motion check and confirm servo centring after fitting to ensure safe flight characteristics.

During replacement, examine all fasteners, link pins, and retained bushings for wear and reinstall in the correct sequence. This item is intended solely as an RC helicopter replacement accessory and must not be used in any non-RC applications.

Will HI0414463 change tail response or tuning?

The control arm maintains the designed linkage geometry; proper installation preserves the original tail response. Any change in tuning is usually due to linkage alignment, not the arm itself.

How robust is this arm for repeated field use?

Constructed for RC use, it will withstand normal hobby loads but inspect it regularly after hard landings or heavy impacts and replace if deformation is noted.

Any recommendations for preventing play in the linkage?

Ensure pins and bushings are snug, use thread lock where appropriate on fasteners, and replace worn linkage items promptly to avoid added play.

Copyright © 2008-2026 rcjaz.com.au All rights reserved