Steel Main Chassis MS-002S-2 for Master Speed MS2.0 by Yokomo  [MS-002S-2]

Yokomo MS-002S-2 jp
Price:
AUD$202.92
Brand:
Yokomo
Model:
MS-002S-2
GTIN:
639342231041
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - MSR-010 category
Write a review

MS2.0 steel main chassis details

This steel main chassis is a direct accessory for the Master Speed MS2.0 platform and is intended as a scale RC main chassis component only. Using steel as the principal material raises the plate's mass compared with common alloy or composite plates and repositions mounting points lower on the chassis plate to lower the vehicle's centre of gravity.

Lowered fixing positions change how suspension geometry and body clearance interact; when fitting, verify screw alignment and perform incremental ride height and droop checks. Expect to retune spring preload and anti-roll settings to match the revised mass distribution rather than altering the powertrain or electronic layout.

Specifications

  • Item Main chassis
  • Material Steel
  • Model Number MS-002S-2
  • Compatibility MSR-020S / MSR-020 / MSR-020A

Compatible Models

  • MSR-020S
  • MSR-020
  • MSR-020A

Fit this chassis when you want a heavier, lower-mounted steel plate to shift balance and roll behaviour on-track; re-check clearances and fine-tune suspension after installation.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will I notice a big change in cornering with this steel chassis?

Yes, the extra mass and lower CG typically reduce roll and alter weight transfer; expect a measurable difference in cornering behaviour that you can refine with spring and anti-roll adjustments.

What tuning steps should I start with after fitting?

Begin by checking ride height and droop, then adjust spring preload and anti-roll bar settings in small increments to find the best balance for the new mass distribution.

Are any chassis mounts changed by the lowered holes?

The mounting geometry shifts downward, which can affect how the suspension and body mount relate; confirm that existing mounts and spacers still provide correct clearance after refit.

Is the fitment reversible if I prefer the original plate?

Yes, the chassis swap is reversible provided you retain original fasteners and spacers; store those parts and note original ride height settings to restore the previous setup.

Copyright © 2008-2026 rcjaz.com.au All rights reserved