Steel Pinion 18T 0.8M - PNGS0818 for Inferno MP Series MP11e by Kyosho  [KY-PNGS0818]

Kyosho PNGS0818 - Steel Pinion Gear (18T/0.8M/?5.0)
Price:
AUD$23.89
Brand:
Kyosho
Model:
KY-PNGS0818
GTIN:
4548565456819
Condition:
Brand New
Quantity Discount
Unit Price You Save
2 $19.18 each $9.42 or 20%
3+ $18.22 each $17.00 or 24%
Write a review

Heavy Duty Pinion for the MP11e

This steel pinion serves as a replacement component for electric touring chassis in the Inferno MP Series MP11e line. The 18-tooth, 0.8M pitch gear is manufactured in steel to deliver improved resistance to wear where a robust motor pinion is needed.

It is ideal for swapping out a worn motor pinion or changing tooth count to influence acceleration versus top speed; remember that a single pinion swap changes final drive ratio and must be matched to the current spur gear and correct mesh setting. Verify shaft fit and mesh clearance before extended running to prevent premature wear.

Quick fit notes: remove the motor from the chassis to access the pinion location, confirm shaft diameter and set screws are secure, rotate the gear to check for any binding, and perform a bench test after tightening.

The PNGS0818 steel pinion is a robust option for MP11e motor drive replacement and a practical choice for basic gearing adjustments on electric touring models.

Remark :
Due to limited stock availability, please notice that some Kyosho items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What makes this pinion more durable?

The steel construction withstands wear better than softer alloys, especially under high rpm and heavy load conditions, extending service life in motor-drive roles.

How often should I inspect the gear?

Inspect the pinion and spur for burrs or tooth wear after every few running sessions and immediately after any impact or unusual noise to catch wear early.

Can I reuse set screws from other gears?

Reuse is acceptable if screws are undamaged and fit correctly; replace stripped or rounded screws to maintain secure mounting and avoid slippage.

Will steel increase noise compared with other materials?

Steel can be slightly noisier than softer materials, but correct mesh and alignment minimize noise while delivering better wear resistance.

Copyright © 2008-2026 rcjaz.com.au All rights reserved