Tamiya 15550 Jr HG Carbon Brake Stay (1.5mm) - 1/32 Mini 4WD Carbon Plate  [15550]

Raw carbon brake stay for 1/32 Mini 4WD

The Tamiya 15550 Jr HG Carbon Brake Stay (1.5mm) is a carbon spare part meant to replace front, rear or side brake stays on 1/32 Mini 4WD models and is listed among Mini 4WD accessories.

This product is a carbon plate with a nominal thickness of 1.5mm, cut for brake stay roles. It is supplied as an unassembled carbon stay for hobbyists who fit replacement mounting plates; no screws or conversion parts are included with the plate.

Material and form: the stay consists of a flat carbon sheet approximately 1.5mm thick. It is intended to be used where standard stay mount hole patterns exist; check hole spacing and screw size against your current stay before installing.

Installation advice and fit checks

• Intended for use on 1/32 Mini 4WD as a front, rear or side brake stay plate.
• Ensure hole alignment matches your car's stay mounts; minor re-drilling can be required for non-standard configurations.
• Pick screws and washers that fit your mounts and take care not to overtighten to prevent edge damage to the carbon.
• Sold as the carbon stay plate only, not a full body or chassis replacement.
• Not designed for Wild Mini 4WD or Scale Mini 4WD upgrade applications.