Tamiya 22010 - GB-01S Full Ball Bearing Set GB-Series Upgrade  [22010]

Tamiya 22010 - GB-01S Full Ball Bearing Set TamTech-Gear OP-2010
Price:
AUD$0.00
Brand:
Tamiya
Model:
22010
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Refine Your GB-Series RC with Tamiya Bearings

The Tamiya 22010 GB-01S Full Ball Bearing Set is a practical replacement for worn bushes on TamTech-Gear cars. Built for GB-01 and GB-02 chassis installations, these bearings cut down rotational friction and help components last longer under regular use. They are suitable for both casual runs and organised events where reliability counts.

Practical Advantages of Ball Bearings

Ball bearings reduce mechanical resistance at shafts and pivots, improving efficiency and lowering heat in the drivetrain. The Tamiya 22010 kit supplies the typical bearing sizes used across the platform, making it a tidy upgrade that simplifies maintenance and tuning.

Yes. The Tamiya 22010 pack is intended as a complete ball bearing conversion for the common GB-01 and GB-02 locations.
Bearing installation usually does not change gear mesh, but check mesh after assembly since reduced play can alter final alignment slightly.
Service frequency depends on conditions; inspect and clean after dusty or wet runs and apply a light bearing oil to keep performance steady.

Copyright © 2008-2025 rcjaz.com.au All rights reserved