Tamiya 22053 XV-02 Aluminium Spur Gear Holder - Off-road friendly spare  [22053]

Tamiya 22053 - XV-02 Aluminum Spur Gear Holder OP-2053
Price:
AUD$12.95
Brand:
Tamiya
Model:
22053
GTIN:
4950344220533
Condition:
Brand New
Available in shop
Write a review

Reinforce your XV-02 spur gear support

The Tamiya 22053 - XV-02 Aluminium Spur Gear Holder swaps in for the factory plastic piece to give the XV-02 chassis a stiffer spur gear mounting point. That reinforcement helps keep the centre shaft aligned during tough runs.

Reliable holding power

Forged from aluminium, the holder clamps the spur gear location more securely than the original material. Users who push high throttle or run rough terrain will notice steadier gear behaviour.

Easy installation on the XV-02

Specifically engineered for the XV-02 layout, this holder fits without complex alterations and works with the existing setup to boost overall driveline reliability.

What tools do I need to fit this part?

A basic RC tool kit is enough: hex drivers, a small wrench and a screwdriver. Remove the old holder and bolt the aluminium unit into the original mounting points.

Is this suited to off-road use?

Yes, the extra rigidity helps keep gears aligned when running on rough or loose surfaces, which is common in off-road RC driving.

Any tips for setup after swapping parts?

After fitting, check the gear mesh by rotating the drivetrain by hand and listen for binding. Adjust motor position or add thin shims to achieve a smooth, quiet mesh.

Copyright © 2008-2026 rcjaz.com.au All rights reserved