Tamiya 22104 44mm Double-Cardan Drive Shafts (2pc) TRF Touring Fit  [22104]

Part Summary

These 44mm drive shafts are built for double-Cardan suspension assemblies used in TRF-style hop-up and 1/10 scale touring cars. Offered as a pair, they serve as replacement or spare shafts where double-Cardan joints are specified. The 44mm length is the defining dimension to match cardan cup spacing and keep intended drivetrain angles.

Typical installation

Place these shafts where a double-Cardan link connects gearbox output to a wheel hub or intermediate coupling. They suit tuned TRF-derived touring layouts and help reduce binding when hubs and cups are correctly aligned.

Fit tips and checks

• Designed for TRF hop-up applications and common 1/10 touring car configurations using double-Cardan couplings.
• Confirm the 44mm length matches the distance between your cardan cups or hub interface prior to fitting.
• Often replaced after wear or impact; visually check joint ends and dimensions before reuse.

Servicing tips

• Ensure cups allow full swivel at operating angles to avoid pre-loading joints.
• Apply recommended grease to joint interfaces to limit wear and inspect for play or corrosion.
• Swap both sides together to retain equal driveline length and balance.