Tamiya 2750071 5x3.5mm Spacer 1 pc Compatible with Model 58276  [2750071]

Price:
AUD$7.80
Brand:
Tamiya
Model:
2750071
Condition:
Brand New
Write a review

Setup Essential for Tight Tolerances

The Tamiya 2750071 5x3.5mm spacer is a handy, no-fuss part for keeping components correctly spaced. It helps prevent unwanted play and supports consistent operation across assemblies.

Adjustment Scenarios for the Spacer

Install this spacer when fine tuning gear mesh, reducing endplay or shimming linkages for better wheel alignment. It is a simple way to refine handling without major changes.

Broad Parts Compatibility

Designed with common Tamiya dimensions in mind, the 5x3.5mm spacer is noted for use with the Tamiya 58276 but fits other models that accept the same size. Keep one in your spares for repairs and setup trials.

Is this spacer the same as the factory part?

This is the Tamiya part listed as 2750071 and matches the 5x3.5mm dimension used in several Tamiya assemblies. Verify against your parts list to confirm fit.

Will I need special tools to fit it?

No specialised tools are required. Small tweezers, a pick or needle-nose pliers make positioning the spacer easier in tight spots.

Can changing spacers damage parts?

If a spacer causes binding or excessive preload, it can affect component life. Fit carefully and check moving parts rotate freely after installation.

Is one spacer enough for maintenance?

You may want several common sizes on hand. A single 5x3.5mm spacer is useful, but a small selection helps cover most adjustments.

Does this spacer suit offroad setups?

It can be used on both onroad and offroad models where the dimension matches. Consider track conditions and test setup changes to see the impact on handling.

Copyright © 2008-2025 rcjaz.com.au All rights reserved