Tamiya 3454074 Suspension Arm Block B for Model 49175 - Suspension Replacement  [3454074]

Price:
AUD$19.68
Brand:
Tamiya
Model:
3454074
Condition:
Brand New
Write a review

Restore Suspension Geometry on TRF414M2

Keep your Tamiya TRF414M2 setup true with the Tamiya RC Suspension Arm Block B. This replacement part is made to the TRF414M2 specification so steering balance and stability remain consistent after service.

Where It Fits

The Suspension Arm Block B matches the TRF414M2 suspension points and is intended as a direct replacement for worn or damaged blocks. Using the correct part helps maintain predictable handling across different surfaces.

Simple Installation Advice

Install the block with uniform screw tension and verify alignment before running. Periodic checks of suspension play and fastener tightness will keep the chassis working as intended.

Is this an OEM replacement?

Yes, this part is produced to match Tamiya TRF414M2 specifications for correct fit and function.

Can impacts damage the block even if it looks intact?

Hard hits can create internal stress or hairline cracks; if handling changes after an impact, replace the block rather than risk failure on track.

Should I upgrade other suspension parts at the same time?

Inspect pins, arms and bushings when replacing the block; worn complementary parts will limit the benefit of a new block.

Any break-in required after fitting?

No special break-in is needed, but check fasteners and alignment after the first short run to confirm everything remains tight and true.

Copyright © 2008-2025 rcjaz.com.au All rights reserved