Tamiya 51051 TRF415 Rear Damper Stay - Track Ready Delrin Part  [51051]

Tamiya 51051 - TRF415 Rear Damper Stay SP-1051
Price:
AUD$18.24
Brand:
Tamiya
Model:
51051
Condition:
Brand New
Write a review

Durable Rear Brace for TRF415 Chassis

The Tamiya 51051 Rear Damper Stay delivers a tougher rear mounting option for the TRF415, made from Delrin to stand up to frequent running. It helps keep damper alignment stable during spirited laps.

Material Notes

Black Delrin provides good impact resistance while retaining enough compliance to avoid brittle breaks. The stay is contoured to sit correctly on TRF415 mounts and maintain consistent suspension motion.

Installation Checklist

Install the Tamiya 51051 Rear Damper Stay by hand-starting all screws, then tighten progressively and evenly. Confirm the stay sits flush and that no binding occurs through the suspension travel.

Is extra drilling needed to fit this part?

No additional drilling should be required for a standard TRF415; the holes align with the factory mounting points.

What screws should I use?

Use the stock screws where possible or OEM-equivalent stainless screws to avoid corrosion and ensure a secure fit.

Can I run it on off-road surfaces?

The Delrin stay is robust enough for light off-road use, but heavy bashing over rough terrain may eventually show wear at the mounting points.

Are replacement parts available?

If screws or mounting hardware wear, replace them with matching-size fasteners; the Delrin stay itself is durable but can also be swapped out easily if needed.

Should I lubricate the mounting points?

Avoid lubricating screw threads with oil; a tiny amount of anti-seize on metal threads is fine, but the Delrin should remain clean to prevent dirt buildup.

Copyright © 2008-2026 rcjaz.com.au All rights reserved