Tamiya 51092 - TB Evolution IV 46mm Swing Shaft for RC Models - Race-Grade Shaft [51092]

Tamiya 51092 - TB Evolution IV 46mm Swing Shaft SP-1092

Price:

AUD$20.11

Brand:

Tamiya

Model:

51092

GTIN:

4950344510924

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

Spares / Hop-ups - Tamiya - TA-05

Race-ready stability from the Tamiya 51092 shaft

The Tamiya 51092 - TB Evolution IV 46mm Swing Shaft for RC Models suits racers and serious hobbyists using TB Evolution IV or TRF415 layouts. The 46mm length helps preserve intended suspension geometry, supporting sharper turn-in and steadier corner exits.

Solid construction for repeatable runs

Finished in black for a clean look, this swing shaft is built for repeatable performance and minimal service intervals. It is a good match for reversible low-weight suspension setups where precise pivoting is required.

Does the shaft require special bearings?

Standard sized bearings used on the TB Evolution IV and TRF415 will work. Inspect bearing fit and replace worn bearings when installing the new shaft for best results.

Will this change handling dramatically?

Expect improved consistency rather than a radical change. The correct length keeps suspension geometry stable so small handling gains are evident on repeat laps.

Any tips for fitting?

Clean the mating surfaces, check for straightness, and torque mounting hardware to the recommended spec. Recheck alignment after a short test run.