Tamiya 51129 TG10-Mk.2 10mm Precision Adjuster Nut Set 4pcs SP-1129  [51129]

Tamiya 51129 - TG10-Mk.2 10mm Adjuster Nut (4 pcs.) SP-1129
Price:
AUD$8.32
Brand:
Tamiya
Model:
51129
Condition:
Brand New
Write a review

Tuning the TG10-Mk.2 with Tamiya 51129 Adjusters

The Tamiya 51129 10mm Adjuster Nuts give modelers a simple way to refine their TG10-Mk.2 chassis. This four piece set is aimed at making small, controllable tweaks to steering geometry and balance.

Where They Fit

These nuts are manufactured to suit TG10-Mk.2 mounting points and will integrate without major alterations. Their 10mm form factor supports consistent adjustments across repeated setups.

Practical Installation Guidance

Install by replacing the current nuts with the Tamiya 51129 set and recheck alignment and steering after a short run. Small incremental turns are recommended when searching for the right feel.

How precise are the adjustments with these nuts?

They allow finer step changes compared to generic nuts, making them suitable when you need to dial in subtle handling differences for competition or testing.

Can they be used with aftermarket linkages?

If the thread size and clearance match, these adjusters can be used with many aftermarket parts. Always verify fit on a bench before final assembly.

Do they change durability of runs?

They do not materially change component durability but do help maintain setup consistency, which reduces the need for frequent corrective maintenance during events.

Copyright © 2008-2025 rcjaz.com.au All rights reserved