Tamiya 53301 - TL01 Stainless Steel Suspension Shafts - Off-road Favourite for TL01  [53301]

Tamiya 53301 - Stainless Steel Suspenion Shafts TL01 OP-301
Price:
AUD$7.95
Brand:
Tamiya
Model:
53301
GTIN:
4950344533015
Condition:
Brand New
Available in warehouse
Write a review

Fit Tamiya 53301 - TL01 stainless shafts to firm up your TL01

Swap the stock screw pins on a Tamiya TL01 for the Tamiya 53301 - TL01 stainless steel suspension shafts to reduce play at the suspension pivots. This straightforward upgrade stiffens the joint interfaces and helps the car track truer through turns.

Contents and quick installation notes

The kit includes four inner shafts (3mm x 48.5mm), four outer shafts (3mm x 37mm) and sixteen 2mm E-rings for secure mounting. The installation is simple for a regular modeller; use needle-nose pliers or an E-ring tool to clip the rings in place without marring the shafts.

Performance advantages of stainless shafts

These stainless shafts offer improved strength and wear resistance compared to stock pins. That leads to steadier suspension travel and less frequent replacement, which is useful for frequent running or tougher surfaces.

Do these shafts suit rough surfaces?

Yes, the increased durability of stainless steel makes these shafts better suited to rougher tracks and hard-packed surfaces where stock pins might wear faster.

How often should I inspect the E-rings?

Check E-rings before each running session or after heavy landings. Replace any ring that shows deformation to avoid shaft movement or loss.

Will these affect damping feel?

They do not change damper internals, but by reducing pivot slop you may notice crisper suspension response and improved feedback from the shocks.

Any tips to avoid binding?

Ensure shafts sit flush and that E-rings are fully seated. Check suspension arms for burrs and confirm free travel before putting the car back on the track.

Copyright © 2008-2025 rcjaz.com.au All rights reserved