Tamiya 54075 RC TB-03 Off-Road Steering Ball Head King Pin OP-1075 [54075]

Tamiya 54075 - RC TB-03 Ball Head King Pin - (Fluorine Coated) OP-1075

Price:

AUD$11.32

Brand:

Tamiya

Model:

54075

GTIN:

4950344540754

Condition:

Brand New

Quantity:

Available in warehouse

Write a review

Description
FAQ

Reduce binding for smoother steering response

The Tamiya 54075 - RC TB-03 Ball Head King Pin uses a fluorine coating to cut friction at the ball connector, adjuster, flange pipe and resin interfaces. This upgrade helps the steering track more consistently during aggressive cornering and varied terrain.

Suitable chassis and use

Made to fit TB-03, TA05 IFS-R, TRF416 and TB Evo 5MS platforms, this part is suitable for racers and hobbyists seeking a reliable steering upgrade without altering suspension geometry.

Contents of the kit

5x9mm Ball Connector: Metal plated to handle wear.
4.5x3.5mm Flange Pipe: Metal plated for a firm connection.
Fluorine-Coated Flange Pipe: Included for TB Evolution IV applications.
TRF414X Spacer: 3x0.7mm spacer for fine spacing control.
3x10mm Hex Screw: Nickel plated for secure fixing.

Does the fluorine finish affect compatibility with ball bearings?

The coating is applied to mating surfaces to lower friction and does not interfere with bearing fit. It complements good bearing selection and lubrication practices.

Is this a direct swap for TB-03 steering parts?

Yes, it installs as a direct replacement on the listed chassis without changing steering geometry. Check your vehicle manual for removal and installation steps.

What routine checks should I do after fitting?

Inspect for play in the ball connector, ensure screws are tight, and confirm smooth free movement through the range of travel after initial runs.

Will this part help reduce servo jitter?

By lowering friction in the linkage, the part can reduce small oscillations caused by resistance. Proper servo tuning and endpoint setup are also important.