Tamiya 54086 CR01 Aluminum Beadlock Ring Set for CR-01 Crawlers  [54086]

Tamiya 54086 - CR01 Aluminium Beadlock Ring (2 Sets) OP-1086
Price:
AUD$22.69
Brand:
Tamiya
Model:
54086
GTIN:
4950344540860
Condition:
Brand New
Write a review

Scale Beadlock Upgrade for Your CR-01

The Tamiya 54086 CR01 Aluminum Beadlock Ring set adds confident bead clamping and a customised look to CR-01 machines. They are aimed at users who need reliable tyre retention on rough tracks.

Durable Anodised Finish

These aluminium rings withstand everyday trail knocks while the anodised surface helps resist corrosion and scuffs, keeping your wheels looking smart during outings.

Compatibility Notes

Designed to match the CR-01 wheel layout, installation is normally direct for stock wheels and uses standard wheel screws. Always trial-fit before final assembly.

Will these change wheel balance?

Adding beadlock rings can alter peripheral mass slightly; after fitting, spin the wheel and check for any imbalance, correcting with small weights if needed.

Do I need to modify my rims?

Most CR-01 rims accept these rings directly. If you run aftermarket rims, verify bolt pattern alignment before tightening all screws.

How do I clean them after wet runs?

Rinse off mud with fresh water, dry thoroughly and apply a light wipe of oil to bare metal fasteners to prevent corrosion; avoid aggressive solvents on the anodised surface.

Copyright © 2008-2026 rcjaz.com.au All rights reserved