Tamiya 94635 MS Reinforced Rear Double Roller Stay Race-Ready Rear Stay  [94635]

Tamiya 94635 - MS Rein. R Double Roller Stay
Price:
AUD$11.60
Brand:
Tamiya
Model:
94635
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Tamiya 94635 - Reinforced Rear Stay for MS Chassis

The Tamiya 94635 MS Reinforced Rear Double Roller Stay gives Mini 4WD drivers a robust rear mounting option to tighten handling through corners. Compatible with MS chassis layouts, the reinforced bracket supports two rollers to reduce unwanted yaw and improve line holding on technical sections.

Constructed for longevity, the component withstands frequent track sessions and minor impacts. The double roller setup helps dampen sudden lateral shifts, letting drivers focus on consistent lines and smoother lap performance.

Will this stay fit modified MS chassis frames?

In most cases it will fit MS-based frames, including many common modifications. Always compare mounting hole positions on your modified frame before fitting.

How should I position the rollers for best results?

Start with rollers parallel to the chassis and set so they engage the track walls cleanly. Small height and offset changes can tune stability without sacrificing corner speed.

What routine maintenance keeps this part working well?

Keep roller bearings clean and lubricated, check screws for loosening after hard runs, and inspect the stay for stress marks after crashes to avoid failure during events.

Copyright © 2008-2025 rcjaz.com.au All rights reserved