Tamiya 94954 JR HG Carbon Rear Roller Stay 1.5mm Performance Stay  [94954]

Tamiya 94954 - JR HG Carbon Multi Roller Stay - Rear 1.5mm (J-Cup 2013)
Price:
AUD$22.41
Brand:
Tamiya
Model:
94954
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Introducing the Tamiya 94954 JR HG Carbon rear roller stay

The Tamiya 94954 JR HG Carbon Multi Roller Stay brings targeted tuning options to Mini 4WD hobbyists. This 1.5mm carbon plate, released alongside the Japan Cup 2013, is built to mount at the rear and offers multiple drilled positions so you can dial in roller placement for different race lines.

Constructed from resilient carbon fiber, the stay trims unnecessary mass while reinforcing mounting points. The pack contains the necessary screws and washers for assembly, and the pattern of holes makes it easy to test different roller setups to find the right compromise between speed and corner stability.

Will I need special tools to fit this part

You only need basic hobby tools such as small screwdrivers and pliers. A fine drill and countersink help if you need to make small alignment changes on certain chassis types.

Does carbon change handling much compared to plastic stays

Carbon is stiffer and lighter than many plastics, which can sharpen handling and reduce flex. The net effect depends on your whole setup, so test with different roller positions.

How should I care for a carbon roller stay

Wipe the carbon clean after dusty runs and check screws for looseness. Replace any stripped hardware and avoid overtightening to prevent delamination around holes.

Copyright © 2008-2025 rcjaz.com.au All rights reserved