Tamiya 9805612 3x10mm Cap Screw for TG-10 - Workshop Pack  [9805612]

Tamiya 9805612 3X10Mm Cap Screw: 44020
Price:
AUD$0.00
Brand:
Tamiya
Model:
9805612
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Practical Fasteners for TG-10 Builds

The Tamiya 9805612 3x10mm cap screw is a no-nonsense replacement part for TG-10 chassis projects. Intended to secure components reliably, these screws are useful for both routine maintenance and when fitting hop-up parts. Their straightforward design makes them a go-to fastener for everyday RC tasks.

Durability and Fit

These cap screws are produced with attention to dimensional accuracy so they seat cleanly in TG-10 mountings. They resist the common wear that affects frequently removed or adjusted fasteners, helping reduce the need for repeated replacements.

Field Service and Quick Changes

Because they are easy to install, the screws keep pit-side repairs quick and simple. Stash a small set with your spare parts to minimise time off the track or trail.

They suit TG-10 mounting points and will perform under typical off-road stresses if installed correctly. Check exposed areas for debris after rough runs to prevent wear.
A matching hex driver or bit from a hobby toolset will do the job. Keep drivers clean and correctly sized to avoid damaging screw heads.
You can reuse screws that show no thread damage and have solid heads, but replace any that feel loose or have worn threads to maintain secure assemblies.
Bring spare cap screws, a matching driver, and a small container for damaged parts. A light thread locker and spare washers are also useful for quick fixes.

Copyright © 2008-2025 rcjaz.com.au All rights reserved