TAMIYA CC01 Rear Upper Steering Tie Rods 2pcs Spring Steel CC16254ST by GPM  [CC16254ST]

Spring steel rear upper tie rod for CC01

This aftermarket rear upper tie rod is a direct-fit linkage for the TAMIYA CC01 chassis, supplied as a set of two. The parts are made from spring steel to replace the stock softer links where the GPM Cc162 mount is fitted.

Note on use: these rods are intended for installation only with the GPM Cc162 mount on an original CC01 chassis. They form part of the steering and axle linkage and are aimed at improving durability and steering response without altering suspension geometry.

Setup suggestions: install each end into the mounting points on the GPM Cc162 mount, ensure correct thread engagement and rod straightness, then check and fine tune toe and steering alignment. Inspect connections regularly, especially during early runs.