TAMIYA CC-02 Upper Suspension Link Mount for Tuning - JR-CC204-GU by Jazrider  [JR-CC204-GU]

Tamiya CC-02 Chassis Aluminum Upper Suspension Link Mount (Gun Metal)
Price:
AUD$8.32
Brand:
JAZRIDER
Model:
JR-CC204-GU
Condition:
Brand New
Available in shop
Write a review

Upgrade for CC-02 upper link pivot stability

This aluminum upper suspension link mount is built for the TAMIYA CC-02 chassis and comes in a gun metal finish to match scale detail. It replaces the stock plastic upper link mount where a stiffer, more consistent mounting point is required during setup and track tuning.

Installation commonly uses the existing chassis holes and original suspension link hardware; always verify hole alignment and fastener length before final torque. Swapping to aluminium changes local flex patterns and can impact steering and camber, so adjust settings gradually while testing.

Functionally this part is a tuning aid: it reduces pivot movement under load, helps keep link angles consistent across runs, and endures repeat setup changes without the deformation seen in some plastics. This product is intended for RC use only and not for actual vehicle applications.

How should I re-tune after fitting this aluminium mount?

After fitting, run a short test and check steering and camber; make small incremental adjustments to toe and camber to compensate for the reduced local flex introduced by the aluminium mount.

Does this change the suspension balance?

The firmer mounting point can slightly alter how loads transfer through the suspension. Expect a crisper response and tune spring or damping settings as needed to restore desired balance.

Any fit notes before I install?

Confirm the chassis mounting hole alignment and that your link hardware clears the mount without binding; fitting issues are usually down to misaligned holes or incorrect fastener lengths.

Copyright © 2008-2026 rcjaz.com.au All rights reserved