Tamiya CR01 One Piece Rear Hub 3RACING CR01-19/LB Performance Part  [CR01-19/LB]

Tamiya CR01 One Piece Rear Hub - 3RACING CR01-19/LB
Price:
AUD$28.36
Brand:
3Racing
Model:
CR01-19/LB
Condition:
Brand New
Write a review

One-piece rear hub for Tamiya CR01

The 3RACING One Piece Rear Hub (CR01-19/LB) is aimed at builders who want a straightforward stability upgrade for the Tamiya CR01. Its integrated layout keeps the wheel interface solid and reduces potential play during aggressive runs.

Practical advantages of the 3RACING hub

Made with the CR01 chassis in mind, this one-piece hub reduces assembly complexity and removes small parts that can loosen over time. That makes it a sensible choice for weekend trail riders and club racers alike.

Quick installation checklist

Start by cleaning the axle and hub area. Slide the hub into position, confirm alignment, and tighten the mounting screws to spec. Recheck the fit after a short run to ensure nothing has shifted.

Will this change wheel alignment?

If installed correctly it should maintain factory alignment. Always verify toe and camber after replacing hub components to ensure proper tracking.

Are bearings affected by this hub?

The hub is designed to work with standard CR01 bearings. Inspect bearings for wear when fitting and replace if there is noticeable play.

Can I run this in wet conditions?

It can be used in wet environments but make sure to clean and dry the hub and surrounding components after runs to prevent corrosion or grit buildup.

Copyright © 2008-2025 rcjaz.com.au All rights reserved