Tamiya CW-01 Clamp Hub Upgrade, Aluminum (2pc) - JR-LB07-LB by Jazrider  [JR-LB07-LB]

Clamp hubs designed for vintage Tamiya buggies

This set of two clamp-type aluminum wheel hubs is supplied for Tamiya CW-01 wheel mounting and matches common vintage 1/10 buggy bodies such as Hornet, Grasshopper, Frog, Lunch Box and Monster Beetle. Identified as JR-LB07-LB, the hubs use an aluminum clamp style to provide a stable wheel-to-axle interface while keeping a compact footprint for stock CW-01 designs.

Compatibility is limited to the CW-01 pattern models listed above; check your wheel hex and axle stub dimensions before installing. These hubs act as direct-replacement pieces that align with existing mounting points and hardware, not as components to change suspension geometry.

Fitment notes: remove the original hub and verify axle threads and wheel hex condition, slide the clamp hub into place on the axle or hex seat, ensure the wheel sits flush with correct alignment, then secure it using the vehicle's existing fasteners. Use correct thread engagement and torque for RC fasteners and confirm there is no binding or undue runout after fitting.

Setup advice: clamp-type aluminum hubs can yield more consistent wheel positioning after remounts and reduce deformation compared to thin pressed hubs. After installation check wheel balance and runout and make incremental adjustments when changing tyre or wheel setups. These parts are intended for scale RC CW-01 vehicles and do not alter steering or suspension geometry themselves.