TAMIYA CW-01 Front Bumper Reinforcement (Aluminium) JR-LB04-BK by Jazrider  [JR-LB04-BK]

Tamiya CW-01 Aluminium Front Bumper Mount (Black)
Price:
AUD$11.59
Brand:
JAZRIDER
Model:
JR-LB04-BK
Condition:
Brand New
Available in shop
Write a review

Aluminium mount for CW-01 chassis

The JR-LB04-BK front bumper reinforcement is an aluminium upgrade crafted for use with the TAMIYA CW-01 chassis. With a black finish, the component provides a stiffer front mounting platform intended to influence handling precision and allow tighter adjustment of front-end geometry.

Used as a structural support in place of the stock attachment, the mount reduces front-end flex and improves the consistency of steering inputs under load. Note that this is a model-specific RC part and not intended for road vehicle use.

Install by removing the original bumper support and aligning this mount to the CW-01 factory points. Verify clearance with the body and servo linkages and ensure fasteners are snug for reliable handling changes.

Will the mount change steering response?

Increasing front-end stiffness typically yields sharper steering feedback and more consistent turn-in; adjust toe and camber settings to balance the change.

Any recommended setup tweaks after fitting?

After fitting, fine-tune front roll stiffness and damping to match the firmer mounting; small anti-roll or damper adjustments can help regain balance.

Do I need special tools to fit it?

Standard RC hand tools suffice for most installs. Use correct screwdriver bits and torque control to avoid over-tightening aluminium fasteners into the chassis.

Copyright © 2008-2026 rcjaz.com.au All rights reserved