Tamiya DT02/DT03/TT02B Rear CVD Shafts Alloy Steel #45 DT3264SC by GPM  [DT3264SC]

Rear CVD half-shafts for Tamiya platforms

This rear constant velocity drive shaft is produced as a replacement for Tamiya DT02, DT03 and TT02B chassis. The driven halves are made from alloy steel #45 and the set is supplied as one pair to replace worn rear drivetrain components.

Compatibility is limited to the chassis listed; this item is NOT suitable for Tamiya 58374. It is intended for hobby use to restore correct drivetrain geometry, reduce play at the rear diff output, and offer a straightforward metal upgrade over worn plastic parts.

Installation is standard for rear CVD swaps: strip the rear hubs and driveline components to access the shaft ends, check set-screws and hex seating, and observe axle alignment through suspension droop to avoid binding. Minor set-screw trimming or light thread-lock on steel fasteners can be used if required.

Keep replacement shafts matched to the correct chassis code for spline count and length, and check bearings and hub hardware when performing the swap.